Description
Description of product:
1. Heater designed for heating composite resin material,improve the flow of its adhesive properties;At the same time it can also be used to heat adhesive when used manual equipment.
Heater use the precision circuit control module to heat,control the temperature tolerance within 1 degree,According to your choice of material and it can set any integer temperatue within 40-70℃
2. Some materials and recommended temperatue
| No | Material | Recommended Temperature (Celsius) |
| 1 | Resin (For Filling) | 39 |
| 2 | Resin (For Bonding) | 55 |
| 3 | Branscan | 38 |
| 4 | Agar Film | Melting 99; Insulation 60 |
| 5 | Sodium Hypochlorite | 60 |
Operation:
1. After plug the power supply,the digital tube is always on ” — ℃ ”
2.After plug the power supply,single press “ ON/OFF/SET ”
Heater goes into the heating state according to the set temperatue at previous power-off
.It automatically stops heating after reaching preset temperatue.
3.After plug the power supply,single press “ + ” or “ – ” into the setup mode.Press “ + ” can increase the preset temperatue.Press “ – ” can decrease the preset temperatue.After setting,single press “ ON/OFF/SET ” into the heating state.It automatically stops heating after reaching preset temperatue.
Notice:
In the setting mode,long press the “+”or “-” to quickly increase or decrease the preset temperatue,any integer within the preset temperatue 40-70 can be selected.
Technical parameter:
1.Power adapter：
Input：AC100-240V 50/60Hz
Output：DC15V2A
2.Heating temperatue range:40℃-70℃，±1℃
